![General extraction error location es1](https://kumkoniak.com/8.jpg)
To use a flintlock rifle effectively, one must become a master at two processes that are at first clumsy and arduous: loading and firing. It’s not ripping open powder cartridges with your teeth and slamming home a ramrod like you’re in The Patriot. To become a skilled flintlock hunter, you must spend time both on the range learning not to flinch as explosions go off near your nose and honing the combination of ammunition and powder.ġ. Don’t smoke around the black powder or your rifle.Ģ. Mark your ramrod to show where it will sit at the muzzle when the gun is loaded. This way you can be sure your load is seated correctly you can also check to make sure the gun hasn’t already been loaded.ģ. Use only black powder or pyrodex, not smokeless black powder, which can damage the firearm.Ĥ. If the rifle fails to fire, keep it pointed downrange in preparation for a hangfire, or delayed discharge.ĥ. Clean the rifle thoroughly after every firing. Black powder causes heavy corrosion and buildup that can damage the rifle or worse, cause an obstruction or explosion.ġ Gather your ammunition. The ammo for a flintlock rifle isn’t a self-contained round like in a modern weapon. There are three main, separate, parts here: fine-grained gunpowder for the first explosion in the “flash pan”, coarser gunpowder for the main explosion in the barrel of the rifle, and the bullet, either a round lead ball or a conical-shaped bullet like a minie ball. The type of powder (coarseness ranges from “F”, or very coarse, to “FFFF”, or very fine), amount of powder and the bullet you use depend on the calibre and rifling “twist” ratio of the rifle, though the main charge of powder that is primed down the barrel is usually between 85 and 100 “grains”, or between 0.19 and 0.23 ounces. Testing different combinations of powder and bullet types at a rifle range is the best way to fine-tune a loadout for accuracy.Ĥ Load the barrel with the ball. Next, align the tube of the speed loader with the muzzle of the rifle. If you’re using a conical bullet or minie ball, make sure the correct end is pointing upward, so it’ll point toward the target once it’s seated in the barrel.
![General extraction error location es1](https://kumkoniak.com/8.jpg)